Be the first to review this product
Venton Antenna Cable, RG-6F-KU, Full Copper, 140dB, 6.9mm, white (Price per meter)
Only 59 left in our own stock
In our stock.
SKU
VENTON-RG-6F-140DB-KU-1M
Antenna cable for DVB signal distribution with excellent 140 dB shielding.
Antenna cable with full copper inner conductor. This results in a lowest loss cable. Suitable for all DVB signals, but you get the most out of this product with DVB-S and DVB-S2 signals. This cable has 5 layers of shielding and has 140 dB noise shielding. So signal will get less noise than with cables with lower shielding. Suitable also for outdoor use.
Please note! This product can not be returned. Order is binding from the moment of order.
Connector installation:
- Strip cable outer layers to the aluminum foil from about 1.5cm distance. Also remove the foil. Braid below the foil must not be damaged.
- Fold the braid back on the cable.
- Strip the inner insulation layer to the core conductor from about 1cm distance.
- Install connector so that the connector has a good contact with the braid. Cable core conductor must not be in contact with the braid or the connector outer parts. Core conductor should come 1-2mm out of an F connector. Screwed F connector is screwed to the cable. Self-install type connector is pushed to the cable. Crimp and compression type connector are installed with appropriate tool. IEC type connector core conductor is connected with a screw on the cable core conductor. Check compatible connectors below.
| Brand | Venton |
|---|---|
| Manufacturer's description | Innenleiter Material: CU-Kupfer Blank |
| Cable type | RG-6 |
| Cable connectors | No connectors |
| DVB-compatibility | DVB-C2 (cable), DVB-C (cable), DVB-S (satellite), DVB-S2 (satellite HD), DVB-T (terrestrial), DVB-T2 (terrestrial HD) |
| Noise shielding (dB) | 140 |
| Damping / 100m | 5 MHz: 1.4 dB 50 MHz: 4.7 dB 100 MHz: 6.9 dB 200 MHz: 9.1 dB 400 MHz: 12.8 dB 800 MHz: 18.2 dB 1600 MHz: 26.3 dB 3000 MHz: 35.9 dB |
| Shielding layers | 5 |
| Meter marks | Yes |
| Impedance (Ohm) | 75 |
| Cable length | 1m |
| Product length (m) | 1 |
| Product diameter (mm) | 6.9±0.1 |
| Product weight (g) | 60 |
| Manufacturer product link | http://www.venton.de/ |
| Country of Manufacture | China |
| Warranty | 24 months |
Household terrestrial antenna guide
Instructions for TV antenna installation, information about different antenna systems and terminology in finnish offered by Suomen antenni- ja teleurakoitsijaliitto ry:n Pientalon antenniopas.
Antennas
If you want to choose all you need easily please check our Terrestrial antenna sets. Please also check our TV antennas and our Terrestrial antenna recommendations for different circumstances.
You can also find radio antennas, satellite antennas and satellite sets in our webshop.
Amplification
Some antennas have built-in amplifiers. Most Televés antennas have intelligent BOSSTech amplifiers that are adjusted atumatically as the signal level changes. You can also find separate amplifiers and power supplies in our webshop.
Antenna signal distribution
You can find our best quality but low-cost antenna cables with connectors or without connectors and separate connectors and adapters.
You can distribute terrestrial antenna signal from one distribution point to all reception points in even level or you can use a main line and taps to get uneven level outputs in different points of the main line. Or you can combine these.
Splitters are used to distribute even level signal from 1 point to all reception points. This is easy and clear. You need a splitter with enough outputs to all reception points.
Taps might be more useful in some situations like long buildings. Taps must be chosen so that first taps get smaller part of the signal so that the main line signal stays strong enough until the end of the main line.
Reception points must have antenna wall sockets that allow you to get each type of antenna signals (terrestrial, satellite and radio) to TVs, DVB receivers and radios.
Combiners allow you to combine different type of antenna signals to 1 cable outside. Then you only need 1 cable to go to the distribution point inside.
Grounding helps to protect your equipment from lightning damages.
Tools
Terrestrial antenna meters allows you to direct your antenna by giving you the signal level coming from the antenna. More advanced models also tell you the signal quality and more detailed channel specific information. Some models even allow you to view TV on the meter screen.
Cable strippers, pliers for installing connectors, installation tools and connecting tools can be found in our tools.
Card readers
If you want to watch pay-tv channels, you also need a separate Antenna HD Ready CI+ CAM for your TV.
DVB receivers
All our terrestrial receivers are compatible with free DVB-T and DVB-T2 TV channels in Finland and in other countries. Some of our terrestrial receivers are also compatible with pay-tv terrestrial channels when a separate Antenna HD Ready CI+ CAM is used. Some of our terrestrial receivers also support more advanced features like 10-20 TV channel simultaneous recording and can be adjusted to your needs. Please also check our Best receivers comparison.
Problem situations
Do you have no idea which cable goes to which room? If you have a lot of cables and don't know which one goes where, you can use a tester.
LTE filter might help if 4G or 5G traffic creates problems for TV channels. Problems might be bigger when there is a lot of 4G or 5G traffic (for example evenings in residential areas).
Ratings & Reviews
Ratings & Reviews
Be the first to review this product
Our recommendations in this category
